Adjusting The Focus, Zoom, And Lens Shift; Adjusting Adjustable Feet - Panasonic SOLID SHINE PT-VMZ51 Operating Instructions Manual

Hide thumbs Also See for SOLID SHINE PT-VMZ51:
Table of Contents

Advertisement

Adjusting the focus, zoom, and lens shift

Adjust the focus, zoom, and lens shift if the image projected to the screen or its position is shifted even if the
projector and the screen are set up in the correct positions.
Focus lever
Fig. 1
1)
Adjust the zoom and the focus. (Fig. 1)
f Operate the focus lever to adjust the focus.
f Operate the zoom lever to adjust the projected image size to fit the screen.
2)
Adjust the lens shift. (Fig. 2)
f Turn the horizontal and vertical lens shift dial and adjust the horizontal and vertical projection position on
the screen. For details, refer to "About lens shift adjustment range" (x page 56).
Note
f It is recommended that the images are projected continuously for at least 30 minutes before the focus is adjusted.
f When the focus is adjusted, the projection screen size also changes slightly. Depending on the image projection situation, repeat Steps 1) to
2) to adjust to the best projection condition.
f Adjust from the [POSITION] menu → [SCREEN ADJUSTMENT] when the projected image is distorted.

Adjusting adjustable feet

Install the projector on a flat surface so that the front of the projector is parallel to the screen surface and the
projection screen is rectangular.
If the screen tilts upward or downward, extend the front adjustable foot and rear adjustable feet to adjust the
projection screen to be rectangular. If the screen tilts in the horizontal direction, adjust the rear adjustable feet to
make the screen level. Adjustable feet can be extended by turning them as shown in the figure. Turning them in
the opposite direction will return them to the original position.
Attention
f Be careful not to block the intake/exhaust vents with your hands or any objects when adjusting the adjustable feet while the light source is
on. (x page 29)
Chapter 3 Basic Operations - Projecting
Zoom lever
Fig. 2
Maximum adjustable range
Front adjustable foot : 37 mm (1-15/32")
Rear adjustable feet : 7.5 mm (9/32") each
Vertical lens shift dial
Horizontal lens shift dial
ENGLISH - 55

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents