Panasonic SOLID SHINE PT-VMZ51 Operating Instructions Manual page 30

r Top
17 18
19 20

:
Projection direction
1 Power indicator <ON (G)/STANDBY (R)>
Indicates the status of the power.
2 Light source indicator <LIGHT>
Indicates the status of the light source.
3 Temperature indicator <TEMP>
Indicates the internal temperature status.
4 Focus Lever
Adjusts the focus.
5 Zoom Lever
Adjusts the zoom.
6 Remote control signal receiver
7 Projection Lens
8 Intake vent
9 Front adjustable foot
Adjusts the projection angle.
10 Rear adjustable feet
Adjusts the projection angle.
11 Exhaust vent
12 Connecting terminals (x page 31)
Attention
f Do not block the intake and exhaust vents of the projector.
The components may deteriorate faster if cooling inside the projector is inhibited.
r Control panel
1 Power <v/b> button
(v: Standby, b: Power on)
Sets the projector to the state where the projector is switched
off (standby mode). Also starts projection when the power is
switched off (standby mode).
2 <VOL-> button / <VOL+> button
Adjusts the volume of the built-in speaker or audio output.
(x page 57)
30 - ENGLISH
Chapter 1 Preparation - About your projector
1
2
3
4
r Bottom
13 Security slot
This security slot is compatible with the Kensington security
cables.
14 <AC IN> terminal
Connects the supplied power cord.
15 Speaker
16 Air filter cover
The air filter unit is inside.
17 Ambient luminance sensor
18 Vertical lens shift dial
Adjusts the projecting position in the vertical direction (vertical
shift).
19 Control panel (x page 30)
20 Horizontal lens shift dial
Adjusts the projecting position in the horizontal direction
(horizontal shift).
21 Burglar hook port
Attaches a burglar prevention cable, etc.
5
6
2
7
8
3 <MENU> button
Displays or hides the main menu. (x page 65)
When the sub menu is displayed, pressing it will return to the
previous screen.
4 <ENTER> button
Determines and executes an item in the menu screen.
5 <INPUT SELECT> button
Switches the input signal to project. (x page 53)
21