Using Remote Control; Installing And Removing Batteries; Setting Remote Control Id Numbers - Panasonic PT-VW430EA Operating Instructions Manual

Using Remote control

Installing and Removing batteries

1 ) Open the cover

Setting Remote control ID numbers

When you use the system with multiple projectors, you can operate all the projectors simultaneously or each
projector individually using single remote control, if unique ID number is assigned to each projector.
After setting the ID number of the projector, set the same ID number to the remote control.
There are 7 different ID codes (ALL, Code 1~Code 6), the initial ID number is [ALL].
Setting the ID number
J
1) While holding down the <MENU> button, press the <IMAGE> button. The number of times you press
the <IMAGE> button corresponds to the desired ID code number.
The number of times to press the <IMAGE> button is as follows:
Code 1= Once, Code 2= Twice, Code 3= 3 times, Code 4= 4 times
Code 5= 5 times, Code 6= 6 times.
2) The ID code is changed when the <MENU> button is released.
Resetting the ID number
J
The ID code is reset to [ALL] (default) by pressing the <MENU> button and <IMAGE> button at the same
time for 5 seconds or more.
Attention
If the <IMAGE> button is pressed 7 times or more, the ID code
z
cannot be changed (the operation is invalid).
Note
For details, please refer to the [Remote control] of the [Setting] menu.
z
( page 56)
Æ
20
- ENGLISH
2 ) Install batteries and close the cover
(Insert the – side first.)
Remove the batteries in the reverse order of
z
installation.
MENU button
IMAGE button