Projector Body - Panasonic SOLID SHINE PT-VMZ51 Operating Instructions Manual

11 <CEC> button
Displays the HDMI-CEC operation screen. (x page 97)
12 <SHUTTER> button
Used to turn off the audio and video temporarily. (x page 57)
13 <MUTE> button
Used to temporarily mute the projector. (x page 57)
14 <STATUS> button
Displays the projector information. (x page 62)
15 <ASPECT> button
Switches the aspect ratio of the image. (x page 61)
16 <DEFAULT> button
Resets the content of the sub-menu to the factory default.
(x page 66)
Attention
f Do not drop the remote control.
f Avoid contact with liquids or moisture.
f Do not attempt to modify or disassemble the remote control.
f Please observe the following contents that are described on the back of the remote control unit (see the picture below).
g Do not use a new battery together with an old battery.
g Do not use unspecified batteries.
g Make sure the polarities (+ and -) are correct when inserting the batteries.
In addition, please read the contents that are related to batteries in the "Read this first!".
Note
f The remote control can be used within a distance of about 20 m (65'7") if pointed directly at the remote control signal receiver. The remote
control can control at angles of up to ± 30 ° vertically and ± 30 ° horizontally, but the effective control range may be reduced.
f If there are any obstacles between the remote control and the remote control signal receiver, the remote control may not operate correctly.
f You can operate the projector by reflecting the remote control signal on the screen. The operating range may differ due to the loss of light
caused by the properties of the screen.
f When the remote control signal receiver is lit with a fluorescent light or other strong light source, the projector may become inoperative. Set
the projector as far from the luminous source as possible.
f The power indicator <ON (G)/STANDBY (R)> will blink if the projector receives a remote control signal.

Projector body

r Front
1 2 3 4 5
6
10 7
r Rear
Chapter 1 Preparation - About your projector
Caution label at the back of the remote control
8
10
9
14
12 13
17 Number (<0> ~ <9>) buttons
Used for entering a password or an ID number in a multiple
projector environment.
18 <FUNCTION> button
Assigns a frequently used operation as a shortcut button.
(x page 61)
19 <ID ALL> button
Used to simultaneously control all the projectors with a single
remote control in a multi-projector environment. (x page 63)
20 <ID SET> button
Sets the ID number of the remote control in a multi-projector
environment. (x page 63)
r Side
15
11
16 8
ENGLISH - 29