Serial In> Terminal - Panasonic SOLID SHINE PT-VMZ51 Operating Instructions Manual

<SERIAL IN> terminal
The <SERIAL IN> terminal of the projector conforms with RS-232C so that the projector can be connected to and
controlled from a computer.
Connection
When connecting directly
When connecting with DIGITAL LINK compatible devices
(Not available for PT-VMZ51S and PT-VMZ41)
Projector connecting terminals
DIGITAL LINK
LAN cable (straight)
Note
f The destination of [RS-232C] (x page 93) must be set according to the connection method.
f When connecting by a DIGITAL LINK compatible device, set the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY
MODE] (x page 92) to [NORMAL] to control the projector in standby mode.
When [STANDBY MODE] is set to [ECO], the projector cannot be controlled during standby.
Pin assignments and signal names
Outside view
(6) (9)
(1) (5)
Communication conditions (Factory default)
Signal level
Sync. method
Baud rate
Parity
Character length
Stop bit
X parameter
S parameter
158 - ENGLISH
Chapter 7 Appendix - Technical information
Projector connecting terminals
D-Sub 9p (female)
D-Sub 9p (male)
DIGITAL LINK compatible device
DIGITAL LINK
Pin No.
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
RS-232C-compliant
Asynchronous
9 600 bps
None
8 bits
1 bit
None
None
Computer
Communication cable (straight)
D-Sub 9p (female)
D-Sub 9p (male)
Signal name
― NC
TXD Transmitted data
RXD Received data
― NC
GND Earth
― NC
CTS
Connected internally
RTS
― NC
Computer
Communication cable (straight)
Details