Panasonic SOLID SHINE PT-VMZ51 Operating Instructions Manual page 98

Changing the menu code
The menu code that calls up the operation menu of the CEC-compatible device varies depending on the device
manufacturer. If you cannot call up the operation menu of a CEC-compatible device from the HDMI-CEC
operation screen, change the menu code setting.
1) Press as to select [HDMI CEC].
2) Press qw to select [ON].
3) Press the <ENTER> button.
f The [HDMI CEC] screen is displayed.
4) Press as to select [MENU CODE].
5) Press qw to switch the item.
f The items will switch each time you press the button.
f Select the menu code from [1] to [6].
Setting the link control
Make settings for the link control between the projector and CEC-compatible devices.
[PROJECTOR -> DEVICE]
Set the link control from the projector to the CEC-compatible device.
1) Press as to select [HDMI CEC].
2) Press qw to select [ON].
3) Press the <ENTER> button.
f The [HDMI CEC] screen is displayed.
4) Press as to select [PROJECTOR
5) Press qw to switch the item.
f The items will switch each time you press the button.
[DISABLE]
[POWER OFF]
[POWER ON/OFF]
[DEVICE -> PROJECTOR]
Set the link control from the CEC-compatible device to the projector.
1) Press as to select [HDMI CEC].
2) Press qw to select [ON].
3) Press the <ENTER> button.
f The [HDMI CEC] screen is displayed.
4) Press as to select [DEVICE
5) Press qw to switch the item.
f The items will switch each time you press the button.
98 - ENGLISH
Chapter 4 Settings - [PROJECTOR SETUP] menu
->
DEVICE].
Disables the power link control from the projector to the CEC-compatible device.
Select this when you do not want the power status of the CEC-compatible device to link with the power status
of the projector.
Enables power-off link control.
When you turn off the power of the projector and put it in standby mode, all CEC-compatible devices
connected to the <HDMI IN 1> terminal or <HDMI IN 2> terminal will enter standby mode.
Power-on link control is disabled.
Enables power-on link control and power-off link control.
If you turn on the projector and start projection with the HDMI1 input or HDMI2 input selected, the CEC-
compatible device connected to the selected input will turn on.
When you turn off the projector and put it in standby mode, all CEC-compatible devices connected to the
<HDMI IN 1> terminal or <HDMI IN 2> terminal will enter standby mode.
->
PROJECTOR].