Table 9-4 Remote Node Network Layer Options Menu Fields - ZyXEL Communications Intelligent Broadband Sharing Gateway P-324 User Manual

Table 9-4 Remote Node Network Layer Options Menu Fields

FIELD
IP Address
Assignment
Rem IP
Address
Rem IP
Subnet
Mask
Gateway IP
Addr
My WAN
Addr
My WAN
Addr
Network
Address
Translation
Metric
Private
9-8
If your ISP did not assign you an explicit IP address, select
Dynamic; otherwise select Static and enter the IP address & subnet
mask in the following fields.
If you have a Static IP Assignment, enter the IP address assigned to
you by your ISP.
If you have a Static IP Assignment, enter the subnet mask assigned
to you.
This field is applicable to Ethernet encapsulation only. Enter the
gateway IP address assigned to you if you are using a static IP
address.
If you have a Static IP Assignment, enter the gateway IP address
assigned to you.
This field is applicable to PPPoE and PPTP encapsulations only.
Some implementations, especially the UNIX derivatives, require the
WAN link to have a separate IP network number from the LAN and
each end must have a unique address within the WAN network
number. If this is the case, enter the IP address assigned to the
WAN port of your Prestige.
Note that this is the address assigned to your local Prestige, not the
remote router.
Use the [SPACE BAR] to select either Full Feature, None or SUA
Only. See the NAT chapter for a full discussion of this feature.
This field is valid only for PPTP/PPPoE encapsulation. The metric
represents the "cost" of transmission for routing purposes. RIP
routing uses hop count as the measurement of cost, with a minimum
of 1 for directly connected networks. Enter a number that
approximates the cost for this link. The number need not be precise,
but it must be between 1 and 15. In practice, 2 or 3 is usually a good
number.
This field is valid only for PPTP/PPPoE encapsulation. This
parameter determines if the Prestige will include the route to this
remote node in its RIP broadcasts. If set to Yes, this route is kept
private and not included in RIP broadcast. If No, the route to this
remote node will be propagated to other hosts through RIP
DESCRIPTION EXAMPLE
Dynamic
SUA Only
3
Yes
Remote Node Setup