Figure 17-13 Telnet Into Menu 24.7.1 - Upload System Firmware - ZyXEL Communications Intelligent Broadband Sharing Gateway P-324 User Manual

DO NOT INTERUPT THE FILE TRANSFER PROCESS AS THIS MAY
17.4.1 Firmware File Upload
FTP is the preferred method for uploading the firmware and configuration. To use this feature, your
computer must have an FTP client.
When you telnet into the Prestige, you will see the following screens for uploading firmware and the
configuration file using FTP.
To upload the system firmware, follow the procedure below:
1. Launch the FTP client on your workstation.
2. Type "open" and the IP address of your system. Then type "root" and
SMT password as requested.
3. Type "put firmwarefilename ras" where "firmwarefilename" is the name
of your firmware upgrade file on your workstation and "ras" is the
remote file name on the system.
4. The system reboots automatically after a successful firmware upload.
For details on FTP commands, please consult the documentation of your FTP
client program. For details on uploading system firmware using TFTP (note
that you must remain on this menu to upload system firmware using TFTP),
please see your manual.
Figure 17-13 Telnet Into Menu 24.7.1 — Upload System Firmware
17.4.2 Configuration File Upload
You see the following screen when you telnet into menu 24.7.2.
17-12
PERMANENTLY DAMAGE YOUR PRESTIGE.
Menu 24.7.1 - System Maintenance - Upload System Firmware
Press ENTER to Exit:
WARNING!
Firmware and Configuration Maintenance