Edit Ip Remote Node Network Layer Options; Figure 9-4 Remote Node Network Layer Options - ZyXEL Communications Intelligent Broadband Sharing Gateway P-324 User Manual

Table 9-3 Fields in Menu 11.1 (PPPoE Encapsulation Specific Only)
FIELD
Schedules
Nailed-Up
Connection
Session Options
Idle Timeout
9.3

Edit IP Remote Node Network Layer Options

Move the cursor to the Edit IP field in Menu 11.1, then press the [SPACE BAR] to set the value to Yes.
Press [ENTER] to open Menu 11.3 - Remote Node - Network Layer Options.
This menu displays the My WAN Addr field for PPPoE and PPTP encapsulations and Gateway IP
Addr field for Ethernet encapsulation.
The next table gives you instructions about configuring remote node network layer options.
Remote Node Setup
You can apply up to four schedule sets here. For more details
please refer to the Call Scheduling chapter.
This field specifies if you want to make the connection to this
remote node a nailed-up connection. More details are given
earlier in this section.
This value specifies the idle time (i.e., the length of time there is
no traffic from the Prestige to the remote node) in seconds that
can elapse before the Prestige automatically disconnects the
PPPoE connection. This option only applies when the Prestige
initiates the call.
Menu 11.3 - Remote Node Network Layer Options
IP Address Assignment= Dynamic
Rem IP Address= N/A
Rem IP Subnet Mask= N/A
My WAN Addr=0.0.0.0
Network Address Translation= SUA only
Metric= 1
Private= No
RIP Direction= None
Version= N/A
Multicast= None
Enter here to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.

Figure 9-4 Remote Node Network Layer Options

Prestige 324 Intelligent Broadband Sharing Gateway
DESCRIPTION EXAMPLE
300 seconds
(default)
9-7