Appendix C Boot Commands; Diagram 6 Option To Enter Debug Mode - ZyXEL Communications Intelligent Broadband Sharing Gateway P-324 User Manual

The BootModule AT commands execute from within the router's bootup software, when debug mode is
selected before the main router firmware (ZyNOS) is started. When you start up your Prestige, you are
given a choice to go into debug mode by pressing a key at the prompt shown in the following screen. In
debug mode you have access to a series of boot module commands, for example
ATLC
firmware) and
Transferring Files chapter.
Bootbase Version: V2.02 | 10/11/2000 13:58:03
RAM: Size = 8192 Kbytes
DRAM Post: Testing: 8192K OK
FLASH: Intel 16M
ZyNOS Version: V324\wa0b05 | 3/5/2001 18:00:34
Press any key to enter debug mode within 3 seconds.
.................................................
ATHE
Enter to view all available Prestige boot module commands as shown in the next screen.
allows you to change the console port speed. The x denotes the number preceding the colon to give the
console port speed following the colon in the list of numbers that follows; e.g., ATBA3 will give a console
port speed of 9.6 Kbps.
flag in the firmware. The
version, vendor name, product model, RAS code revision, etc.
system. Most other commands aid in advanced troubleshooting and should only be used by qualified
engineers.
Boot Commands
(for uploading the configuration file). These are already discussed in the

Diagram 6 Option to Enter Debug Mode

ATSE
displays the seed that is used to generate a password to turn on the debug
ATSH
command shows product related information such as boot module
Appendix C
Boot Commands
ATUR
ATGO
allows you to continue booting the
(for uploading
ATBAx
7