Table of Contents
Advertisement
This chapter provides information on configuring remote management (SMT menu 24.11).
24.1 Remote Management Overview
Remote management allows you to determine which services/protocols can access which Prestige interface
(if any) from which computers.
You may manage your Prestige from a remote location via:
To disable remote management of a service, select Disable in the corresponding Server Access field.
24.1.1 Remote Management Limitations
Remote management over LAN or WAN will not work when:
5. A filter in SMT menu 3.1 (LAN) or in menu 11.5 (WAN) is applied to block a Telnet, FTP or Web
service.
6. You have disabled that service in one of the remote management screens.
7. The IP address in the Secured Client IP field does not match the client IP address. If it does not
match, the Prestige will disconnect the session immediately.
8. There is an SMT console session running.
9. There is already another remote management session of the same type (web, FTP or Telnet)
running. You may only have one remote management session of the same type running at one time.
10. There is a web remote management session running with a Telnet session. A Telnet session will be
disconnected if you begin a web session; it will not begin if there already is a web session.
24.1.2 Remote Management and NAT
When NAT is enabled:
Use the Prestige's WAN IP address when configuring from the WAN.
Remote Management
Internet (WAN only)
LAN only
Remote Management
ALL (LAN and WAN)
Neither (Disable)
Prestige 202H User's Guide
Chapter 24
24-1
Advertisement
Table of Contents
