ZyXEL Communications Prestige 202H User Manual page 96

Prestige 202H User's Guide
FIELD
Dial-in User
IP Pool
IP Start Addr
IP Count (1, 2)
Session Options:
Edit Filter Sets
Once you have completed filling in this menu, press [ENTER] at the message "Press ENTER to Confirm..."
to save your configuration, or press [ESC] to cancel.
10.3.1 Default Dial-in Filter
Use Menu 13.1 – Default Dial-in Filter to specify the filter set(s) to apply to the incoming and outgoing
traffic between all dial-in users and your Prestige. Note that the filter set(s) only applies to the dial-in users
10-4
Table 10-2 Menu 13 Default Dial-in Setup
If set to Yes, the Prestige will allow a remote host to specify its
own IP address.
If set to No, the remote host must use the IP address assigned
by your Prestige from the IP pool, configured below. This is to
prevent the remote host from using an invalid IP address and
potentially disrupting the whole network.
This field tells your Prestige to provide the remote host with an IP
address from the pool. This field is required if Dial-In IP Address
Supplied By: Dial-in User is set to No. You can configure this
field even if Dial-in User is set to Yes, in which case your
Prestige will accept the IP address if the remote peer specifies
one; otherwise, an IP address is assigned from the pool.
This field is applicable only if you selected Yes in the Dial-In IP
Address Supplied By: IP Pool field.
The IP pool contains contiguous IP addresses and this field
specifies the first one in the pool. The IP start address is the start
of a series of consecutive IP addresses.
In this field, enter the number (1 or 2) of addresses in the IP
Pool. For example, if the starting address is 192.168.135.5 and
the count is 2, then the pool will have 192.68.135.5 and
192.68.135.6. The IP count is the number of consecutive IP
addresses allowed.
Press [SPACE BAR] and then [ENTER] to select Yes to edit the
filter sets. Keep in mind that the filter set(s) will only apply to
remote dial-in users but not the remote nodes.
NOTE: Spaces and [–] symbol are accepted in this field. For
more information on customizing your filter sets, see Chapter 9 –
Filter Configuration. The default is blank, i.e., no filters.
DESCRIPTION EXAMPLE
Yes (default)
No (default)
1
No (default)
Dial-in Setup