ZyXEL Communications Prestige 202H User Manual page 71

FIELD
NAT
Address Mapping
Set
Telco options:
Transfer Type
Multilink
Idle Timeout
Idle Timeout only applies when the router initiates the call.
At this point, the SMT will ask if you wish to test the Internet connection. If you select Yes, your router will
call the ISP to test the Internet connection. If the test fails, note the error message that you receive on the
screen and take the appropriate troubleshooting steps.
Internet Access Setup
Table 7-2 Menu 4 Internet Access Setup
Choose from None, Full Feature or SUA Only. When you select Full Feature you
must configure at least one address mapping set. See the chapter on NAT for a full
discussion of this new feature.
A NAT Server Set is a list of LAN side servers mapped to external ports (similar to
the old SUA menu). You may enter any server set number up to 10, but the first one
is used for SUA only.
This field specifies the type of connection between the router and this remote node.
Select 64K, or Leased.
The router uses the PPP Multilink Protocol (PPP/MP) to bundle multiple links in a
single connection to boost the effective throughput between two nodes. This option
is only available if the transfer type is 64K. Options for this field are: Off, BOD and
Always.
This value specifies the number of idle seconds that elapses before the remote node
is automatically disconnected. Idle seconds is the period of time when no data is
transmitted from your router. Administrative packets such as RIP are not counted as
data.
Prestige 202H User's Guide
DESCRIPTION
7-3