Trouble Indications - Toshiba TLP-MT7E Owner's Manual

64

Trouble indications

If there is some problem inside the projector,
the indicators light up or blink.
Control panel
(Main unit side)
AUTO
KEYSTONE
VOL/ADJ.
ENTER
MENU
TEMP LAMP
BUSY
AUTO
SET
EXIT
INPUT
ON/STANDBY
ON
FAN
Indicator
TEMP LAMP TEMP LAMP ON ON
The power does not come on.
( off )
Malfunction of the unit.
BUSY FAN
• Unplug the power cord and call the dealer.
(Lit in red)
Or
The lamp turns off or does not light up.
TEMP LAMP TEMP LAMP ON ON
The projector will return to the standby mode in about 2 minutes. If the
(Lit in red) (Lit in red)
projector does not operate normally when the power is switched on again,
BUSY BUSY FAN FAN
the lamp is at the end of its duration life or the unit has a fault.
• Lamp's duration life is over, replace the lamp with a new one.
• Unplug the power cord and call the dealer.
The power turns off or does not come on.
TEMP LAMP TEMP LAMP ON ON
The inside is too hot, or the projector has been working in an area of high
(Lit in red)
temperature.
BUSY BUSY FAN FAN
• Place the projector correctly so the intake and exhaust fans' holes are not covered.
(Lit in green or
• Turn the projector off, and leave it for a while, and turn it on again.
turns off)
• Clean the air filter.
Or
Or
(Lit in red) (Lit in orange) (Lit in green) * The icon
* The projector returns to the standby mode after the fault display has been
shown for about 2 minutes.
The power turns off or does not come on.
TEMP LAMP TEMP LAMP ON ON
Trouble with the cooling fan.
(Lit in red)
BUSY BUSY FAN FAN
• Unplug the power cord and call the dealer.
Or
* The icon
(Lit or flashing
(Lit or flashing
* The projector returns to the standby mode after the fault display has been
in red)
in orange)
shown for about 2 minutes.
TEMP LAMP TEMP LAMP ON ON The power turns off or does not come on.
(Lit in red) The lamp cover is not properly attached.
(Flashing in orange)
BUSY BUSY FAN FAN
• Unplug the power cord and reattach the lamp cover.
* The icon
* The projector returns to the standby mode after the fault display has been
shown for about 2 minutes.
Notes
• If abnormality occurs while operating, unplug the power cord.
• When reinserting the power cord before the lamp has cooled, please wait until the lamp has cooled sufficiently before
use. When the lamp is at a high temperature, it may not light and the duration life will be shortened.
65
appears before the power turned off.
appears before the power turned off.
appears before the power turned off.
68
69