Trouble Indications - Toshiba TDP ET20/U Owner's Manual

Trouble indications

The indicator lights inform you of internal abnormalities.
LED indicators
No LED lit
Red LED is flashing at ON/
STANDBY indicator (2Hz)
Red LED is flashing at ON/
STANDBY indicator (5Hz)
Red LED lit at ON/STAND-
BY indicator
No power
⇒ Problem with projector
• Unplug the power cord, and contact your dealer.
⇒ The lamp cover is not properly attached.
• Unplug the power cord, and reattach the lamp cover.
Power went out during use
⇒ Internal overheating, or the outside temperature is too high.
• Place the projector so that the air intake and exhaust are not
blocked.
• Unplug the power cord and wait for a short while, then turn
the power back on.
❈ The icon will appear before the power goes out.
❈ After approx. one minute of abnormal display, the projector
returns to the standby state waiting for internal cool down.
Power went out during use
⇒ Problem with internal cooling fan.
• Unplug the power cord, and contact your dealer.
❈ The icon will appear before the power goes out.
❈ After approx. one minute of abnormal display, the projector
returns to the standby state waiting for internal cool down.
Power went out during use, or won't come on
⇒ Lamp temperature is high so that it is difficult to turn on,
the lifetime of the lamp has ended or the projector is
malfunctioning.
• Unplug the power cord and wait for a short while, then turn
the power back on.
• If a lamp burns out, replace it with a new one.
❈ After approx. one minute of abnormal display, the projector
returns to the standby state waiting for internal cool down.
53
State/Problems