Turning The Power Off - Toshiba TLP-MT7E Owner's Manual

28

Turning the power off

Remote control
ON /
STANDBY 1,2
INPUT
KEYSTONE AUTO SET
FREEZE MUTE
PIP CALL RESIZE
MENU
VOL/ADJ
ENTER EXIT
CT-90072
Control panel
(Main unit side)
AUTO AUTO
KEYSTONE SET
VOL/ADJ.
ENTER EXIT
MENU INPUT
ON/STANDBY
1,2
TEMP LAMP ON
2
BUSY FAN
Indicators
Press ON/STANDBY after using the projector.
1
ON/STANDBY
An instruction message appears.
ON/
STANDBY
Press ON/STANDBY again.
ON/STANDBY
2
Cooling starts. Once cooling is completed, the LAMP and FAN
indicators turn off and the standby mode is set. (The ON
ON/
indicator turns in orange.)
STANDBY
LAMP
(Green)
Flashing
A
To protect the light source lamp, the LAMP indicator blinks as long as
A
a minimum of cooling is necessary. The power cannot be turned back
on during this time. Unplugging the power cord at this time will
shorten the lamp's duration life.
The cooling fan continues to run for a while to expel the heat
B
remaining inside. If you are in a hurry, however, you may unplug the
power cord at this time.
The standby mode is set.
C
Notes
• The projector consumes about 20W of power in the standby mode. We recommend you to
unplug the power cord when not using the projector for long periods of time.
• Be sure that the LAMP indicator has turned off before unplugging the power cord. Cutting the
power by unplugging the power cord while the projector is operating or the light source lamp
is being cooled will shorten the lamp's duration life. Should fault or some other irregularity
arise with this unit, unplug the power cord.
• When reinserting the power plug before the lamp has cooled, please wait until the lamp has
cooled sufficiently before use. When the lamp is at a high temperature, it may not light and
the duration life will be shortened.
ON LAMP ON
(Orange) (off) (Orange)
FAN FAN
(Green) (Green)
B
LAMP ON
(off) (Orange)
FAN
(Off)
C