Toshiba TLP-MT7E Owner's Manual page 26

26
Projection on the screen (continued)
Remote control
ON /
STANDBY
3
INPUT
KEYSTONE AUTO SET
FREEZE MUTE
PIP CALL RESIZE
MENU
VOL/ADJ
ENTER EXIT
CT-90072
Control panel
(Main unit side)
AUTO AUTO
KEYSTONE SET
The types of input sources selected when the INPUT button is pressed repeatedly can be
VOL/ADJ.
set from the menu screen.
(At shipping from factory, the projector is set so that the component signal source input to
the COMPONENT IN connector and the video signal source input to the VIDEO jack can
be selected.)
ENTER EXIT
MENU INPUT
3
• If you project an image from a computer with an LCD screen while monitoring the image on
ON/STANDBY
TEMP LAMP ON
• An image on a computer is displayed enlarged or reduced, so quality of the screen
BUSY FAN
• The projector can be also applied to DDC2B (Display Data Channel 2B). If your computer is
3 Select the input source.
INPUT
Press the INPUT button repeatedly to select it.
The icon of the input source selected appears.
INPUT
Y/P /P
B R
Note
38
(Signal sent from the computer)
the computer, the image may not be projected properly, depending on the computer model.
In this case, turn off the computer display. For details on controlling the computer display,
etc., refer to the computer's manual and description on the software for the computer used.
becomes a bit inferior.
applied to the DDC, start up your computer after turning on the projector.
Video S-Video Computer
Continued