Start Point Measuring - Pentax R-200 Series Instruction Manual

The current station is the fore sight point of the previous station which you select as a next station.
The back sight point of current station is the previous station.
The following limitations are made.
More than one traverse route can't be measured at the same time.
Don't store other data while you are measuring the traverse route.
When one traverse route is finished, perform the traverse calculation before you store other data.
Don't turn the power supply off until the measurement at one start point or at one corner point is
completed.
Don't escape from the MEASURE screen.
You can't use a duplicate PN in one Job. And you can't overwrite the PN in the traverse.
The same traverse route can't be calculated again.
Polar coordinates data of back sight and station points can't be seen in the EDIT THE POLAR DATA
function. But it is sent properly in SEND POLAR DATA function.
Traverse
From the PowerTopoLite screen, Press the [F1][TRAV] of the PowerTopoLite screen to view the
TRAVERSE screen.

11.1 Start point measuring

Select 1.START POINT first to start new traverse.
Note
More than one traverse route can't be
measured at the same time.
Please start the new traverse route after
another traverse route is finished.
Press [ENT] to view the STATION POINT SETUP screen.
The / mark is used to scroll up / down. 6. ppm is viewed by .
Point name, PN, input
Press [ENT] to view the PN screen.
76