12.4 Calculation
Press [F1] [NO] on 12.2 IP POINT CONFIRM screen or [F5]
[ENT] on 12.3 IP POINT CONFIRM to start calculation.
Press [F5][RECORD] to save the calculation results.
NOTE: In case the calculation results don't appear and an error message [CAN'T CALCULATE THE
ROAD] is displayed, check input coordinates and parameter again.
1) On relation between BP-IPI and BC (or KA), BC (or KA) exists before BP and geometric
relationship isn't consistent. Same thing happens to EP.
2) In case KE exist before KA.
3) When curve section is consecutive, parameter of the curve element is not consistent with the
straight section between IP.
4) Straight section between IP is not consistent with the curve section.
5) Integral part of coordinate of principal peg exceeds 8 digits.
NOTE: If integral part exceeds 8 digits, an error message [TOO LARGEDATA, CAL STOP] is displayed
and calculation is stopped.
NOTE: Numerical part of measurement point name of number peg exceeds [999] and becomes more
than 1,000, under-3 digit is used as a measurement point name of number peg.
NOTE: In case created coordinates exceed 1,000 before calculation reaches end point, an error
message tells you that it is impossible to make calculation until end point, [OVER 1000
POINTS, CAL CAN'T FINISH] is displayed. Select [ESC] and divide route section. Then
recalculate, or press [CONT] to continue the calculation, but in this case you have to
understand that coordinate calculation is not done completely.
NOTE: Calculated coordinate is stored in the selected job file. If you carry out recording even though
the same measurement point name as that of the calculation result exists in the job, the same
measurement point name is recorded in the job file.
NOTE: When you want to stop function on the way, press [ESC] several times to return.
NOTE: Since a lot of data is recorded at the same time, it may take some time to complete all the data.
Do not remove the battery during recording as it may damage the instrument.
NOTE: IP point is not stored.
86