Spa (Set Physical Address); Sbr (Set Baud Rate); Con (Set Lcd Contrast) - Comtech EF Data UT-4500 Series Installation And Operation Manual

UT-4500 Series C- and Ku-Band Up Converters
Serial Interface Operation
8.7.2.9

SPA (Set Physical Address)

Use SPA to set the physical address of the unit. The default address is 001.
Description
Set Physical Address:
Confirmation:
Return Physical Address:
Confirmation:
8.7.2.10

SBR (Set Baud Rate)

Use SBR to set the serial interface baud rate. The default baud rate is 9600.
Description
Set Baud Rate:
Confirmation:
Return Baud Rate:
Confirmation:
8.7.2.11

CON (Set LCD Contrast)

The CON legacy command does not control any current production unit
hardware. Its syntax is still supported to allow backwards compatibility with
initially released chassis monitor and control applications. The default LCD
contrast is 15.
Description
Set Contrast:
Confirmation:
Return Contrast:
Confirmation:
Details
<DEV/SPA_xxx{cr} where:
xxx = 1 to 255
>DEV/SPA_xxx{cr}{lf}]
<DEV/SPA_{cr}
>DEV/SPA_xxx{cr}{lf}]
Details
<DEV/SBR_xxxx{cr} where:
xxxx = 1200, 2400, 4800, 9600, 19K2, or 38K4
>DEV/SBR_xxxx{cr}{lf}]
<DEV/SBR_xxxx{cr}
>DEV/SBR_xxxx{cr}{lf}]
Details
<DEV/CON_xx{cr} where:
xx = 0 to 30
>DEV/CON_xx{cr}{lf}]
<DEV/CON_{cr}
>DEV/CON_xx{cr}{lf}]
8–14
MN/UT4500.IOM
Revision 3