Skoda FABIA II 2007 Workshop Manual page 117

FABIA II 2011 ➤
Automatic gearbox 0AM - Edition 02.10
The small engaging bearing fits in only one position due to the 4
grooves.
If the clutch was replaced, the adjusting washer also belongs un‐
der the bearing.
– While "turning" the bearing, check if it is correctly installed and
the grooves are correctly positioned.
– Fix the adjusting washer -A- with 3 drops of glue -AMV 195
KD1 01- -arrows-.
This prevents that the washer slips out of its position when the
clutch is inserted.
The large adjusting washer is used for the clutch "K 1", the small
one is used for the clutch "K 2".
– Turn back the spindle of the extractor -T10373- .
– Insert the clutch.
– Insert the clutch into the gearbox using the extractor -T10373- .
– "Turn back" the spindle beforehand.
Note
The clutch is self-adjusting. Vibrations can have a negative effect
on the adjusting device. Therefore do not let the clutch fall. Do not
let the clutch fall into the gearbox when installing it.
26
Rep. Gr.30 - Clutch