Rack Mounting - Planet WSD-800 User Manual

2.2.2 Rack Mounting

To install the Switch in a 19-inch standard rack, please follows the instructions described below.
Step1: Place the Switch on a hard flat surface, with the front panel positioned towards the front side.
Step2: Attach the rack-mount bracket to each side of the Switch with supplied screws attached to the package.
Figure 2-7 shows how to attach brackets to one side of the Switch.
You must use the screws supplied with the mounting brackets. Damage caused to the parts by
Caution:
using incorrect screws would invalidate the warranty.
Step3: Secure the brackets tightly.
Step4: Follow the same steps to attach the second bracket to the opposite side.
Step5: After the brackets are attached to the Switch, use suitable screws to securely attach the brackets to the
rack, as shown in Figure 2-8.
Step6: Proceeds with the steps 4 and steps 5 of session 2.2.1 Desktop Installation to connect the network cabling
and supply power to the Switch.
User's Manual of WSD-800 / WGSD-910/WGSD-1022C
Figure 2-7 Attach brackets to the Switch.
Figure 2-8 Mounting the Switch in a Rack
-14-