Vlan Configuration - Planet WSD-800 User Manual

Because some devices on a network may be tag-unaware, a decision must be made at each port on a tag-aware
device before packets are transmitted – should the packet to be transmitted have a tag or not? If the transmitting
port is connected to a tag-unaware device, the packet should be untagged. If the transmitting port is connected to
a tag-aware device, the packet should be tagged.
Default VLANs
The Switch initially configures one VLAN, VID = 1, called "default." The factory default setting assigns all ports on
the Switch to the "default". As new VLAN are configured in Port-based mode, their respective member ports are
removed from the "default."
VLAN and Trunk Groups
In order to use VLAN segmentation in conjunction with port trunk groups, you can first set the port trunk group(s),
and then you may configure VLAN settings. If you wish to change the port trunk grouping with VLAN already in
place, you will not need to reconfigure the VLAN settings after changing the port trunk group settings. VLAN
settings will automatically change in conjunction with the change of the port trunk group settings

4.7.1.2 VLAN Configuration

Port-based VLAN Configuration
Packets can only be broadcast among other members of the same VLAN group. Note all unselected ports are
treated as belonging to the default system VLAN. If port-based VLAN are enabled, then VLAN-tagging is ignored.
1. On VLAN Configuration table, choose Port-based VLAN. Click on the "OK" button.
2. The main page then change to Port-base VLAN table, click on the "Add/Modify" button to create a new VLAN
group.
3. The Port-base VLAN Confirutation table then pops up, enter the VLAN group ID, VLAN name and select the
member ports for the VLAN.
4. Click the "OK" button to add the VLAN.
5. Select the ports in the Port List field and click on the Add button to add the member ports to the VLAN. The
selected VLAN member then shows in the VLAN Member field.
User's Manual of WSD-800 / WGSD-910/WGSD-1022C
-50-