Static Routing Port - Planet WSD-800 User Manual

4.9.5 Static Routing Port

This function is to configure ports to be the member of IGMP Groups in VLANs.
To do this, fill the Port List field and the VID field for the static routing and click on the "Add" button to save.
Static Routing Port Configuration
Port List: Manual specifies the ports which send and receive multicast traffic (e.g. 1-3,7)
VID: The VLAN-ID of the Static Routing Port.
The range is between 1~4094; VLAN 0 means All VLAN
Multicast VLAN Tunnel Configuration
Multicast VLAN Tunnel: Enable or Disable Multicast groups stream be transmitted cross VLANs
Multicast group member VLAN-ID: Specifies the VLAN to be member of the Multicast groups and
crossed from the VLAN at Static Routing Port Configuration. There're up to 28 VLAN members. Once
the VLAN members and the VLAN of Static Routing Port are assigned, all the Multicast group stream at
the VLAN of Static Routing Port will be forwarded to member VLANs.
The VLAN must be configure to 802.1Q VLAN mode
NOTE:
Configure Sample:
To realize the Multicast traffic cross over different VLANs, the IGMP Snooping protocol and VLAN protocol have to
cooperate with each other. First we have to assign the Static Routing Port to the specify port with VLAD ID, and
then add VLANs to be the multicast group members. After that, ports belong to the member VLANs are able to
receive multicast traffic cross VLAN. But they are not able to access each other.
User's Manual of WSD-800 / WGSD-910/WGSD-1022C
-84-