Rack Mounting - Planet gsd-1002vhp User Manual

Step 5: Supply power to the 802.3at PoE+ Switch.
A. Connect one end of the power cable to the 802.3at PoE+ Switch.
B. Connect the power plug of the power cable to a standard wall outlet.
When the 802.3at PoE+ Switch receives power, the Power LED should remain solid
Green.

3.2 Rack Mounting

To install the 802.3at PoE+ Switch in a 19-inch standard rack, follow the
instructions described below.
Step 1: Place your 802.3at PoE+ Switch on a hard flat surface, with the front
panel positioned towards your front side.
Step 2: Attach a rack-mount bracket to each side of the 802.3at PoE+ Switch
with supplied screws attached to the package. Figure 3-2 shows how to
attach brackets to one side of the 802.3at PoE+ Switch.
Figure 3-2: Attaching the Brackets to the 802.3at PoE+ Switch.
You must use the screws supplied with the mounting brackets.
Damage caused to the parts by using incorrect screws would invali-
date the warranty.
Step 3: Secure the brackets tightly.
Step 4: Follow the same steps to attach the second bracket to the opposite side.
24 -P or
t 10 /1 00
SF P Et he /1 00 0T
rn et Sw 80 2. 3a
itc h
t Po E
+ 2- Po
rt G ig ab
2 it
4 6
PoE Port PoE 8
Statu s 10 12 2
14
16 4
18 20
22 6
PWR 1 24
3 5 8
PoE 7
9 11
13 SFP 10
15 17
1000 19
LNK 21
10/1 00 ACT 23 25 LNK
LNK 26
PoE In-U ACT
ACT se
Stan dard
VLAN
Exten d
1
3
5
7
9
12
14
16
18
20
22
24
11 GS W -26
13 20 VH P
15
SFP
17
19
21
23
25
26
21