Rack Mounting - Planet SGS-5220-24P2X User Manual

2.2.2 Rack Mounting

To install the Managed Switch in a 19-inch standard rack, please follow the instructions described below.
Place the Managed Switch on a hard flat surface, with the front panel positioned towards the front side.
Step 1:
Attach the rack-mount bracket to each side of the Managed Switch with supplied screws attached to the package.
Step 2:
Figure 2-2-2 shows how to attach brackets to one side of the Managed Switch.
Secure the brackets tightly.
Step 3:
Follow the same steps to attach the second bracket to the opposite side.
Step 4:
After the brackets are attached to the Managed Switch, use suitable screws to securely attach the brackets to the
Step 5:
as shown in Figure
Figure 2-2-2: Attach Brackets to the Managed Switch.
You must use the screws supplied with the mounting brackets. Damage caused to the parts by
using incorrect screws would invalidate the warranty.
2-2-3.
Figure 2-2-3: Mounting Managed Switch in a Rack
User's Manual of SGS-5220 Series
29
rack,