Trane CVHE Information Manual page 12

Purge Total Pumpout Time/ Purge Total Run
Time
The following screen(s) does not appear if the
selected Purge Control/Type is "Stand-Alone Purge."
Purge Total Pumpout Time: xx,xxx.x Min
Purge Total Run Time:
Purge Operating Mode/Purge Status
The following screen(s) does not appear if the
selected Purge Control/Type is "Stand-Alone Purge."
Purge Operating Mode:
Purge Status:
Possible values of [Mode] are: Auto, Stop, On, or
Adaptive.
Possible values of [Status] are:
Idle
Running
Pumpout
Service Pumpout
Running - Pumpout Inhibited
By Low Temp.
Pumpout Maximum Rate
Disabled
Saturated Evap Temperature/Evap Refrigerant
Pressure Compressor Discharge Temp
Compressor Discharge Temperature shown only if
discharge temperature is installed.
Saturated Evap Rfgt Temp: xxx.x f/c
Compressor Discharge Temp: xxx.x f/c
Compressor Starts and Running Time
The starts and hours counters are displayed as
follows:
Compressor Starts: xxxxx
Compressor Running Time: HRS:MIN:SEC
Information Manual
xx,xxx.x Hrs
[Mode]
[Status]
(Condensing Unit is Off)
(Condensing Unit is On)
(Temperature initiated
Pumpout)
(Pumpout initiated by the
service switch)
(Pumpout inhibited by low
liquid temp)
(Max. Pumpout Rate alarm
disabled)
Discharge Oil Pressure, Oil Tank Pressure
This screen is only displayed if the "Oil Pressure
Protection" setpoint is set to "Transducer" or "Xducer
& Switch."
Discharge Oil Pressure:
Oil Tank Pressure:
Differential Oil Pressure, Oil Temperature
This screen is only displayed if the "Oil Pressure
Protection" setpoint is set to "Transducer" or "Xducer
& Switch."
Differential Oil Pressure: xxx.x [units]
Oil Tank Temperature: xxx.x f/c
' Differential Oil Pressure:
displayed if the "Oil Pressure Protection" setpoint is
set to "Transducer" or "Xducer & Switch." If 'Switch' is
selected as the setpoint, then ' Differential Oil
Pressure Switch: [Status]' is displayed where
Status is open or closed.
For FastPak, Differential Oil Pressure: xxx.x [units],
this screen is only displayed if the "Oil Pressure
Protection Setpoint" is set to "Diff Xducer" If 'Switch'
is selected as the setpoint, then ' Differential Oil
Pressure Switch: [Status]' is displayed where
Status is open or closed.
The Possible value for [units] is "psid" or "kPa"
dependent upon whether English or SI units are
selected.
Bearing Temperatures #1 and #2
The following will be displayed only if the Bearing
Temp Sensors Option is Installed.
Bearing Temperature 1:
Bearing Temperature 2:
Evaporator Entering and Leaving Water
Temperatures
Evap Entering Water Temp: xxx.x f/c
Evap Leaving Water Temp: xxx.x f/c
ASHRAE Guideline 3 Report
xxx.x psig
xxx.x psig
xxx.x [units]' is only
xxx.x f/c
xxx.x f/c
7