External Analog Input Type Selection; 4-20 Ma/2-10 Vdc; Tracer Option; Tci Option - Trane CVHE Information Manual

Machine Configuration
This option screen applies to both the Evap and
Cond differential water pressure sensors for both
systems less than or equal to 150 psig (Sensors at
the Chiller Module) and systems greater than 150
psig (Sensors at the Options Module).

External Analog Input Type Selection,

4-20 ma/2-10 VDC

External Setpoint Inputs:
Press (+)(-) to Change Setting
Possible values for status are: 4-20ma (Factory
Default) and 2-10 VDC.

Tracer Option

Tracer Option:
[status]
Press (+)(-) to Change Setting
Possible values for status are: Installed and Not
Installed (Factory Default).

TCI Option

TCI Option: [status]
Press (+)(-) to Change Setting
Possible values for status are: Installed and Not
Installed (Factory Default).

Printer Option

Printer Option:
Press (+)(-) to Change Setting
Possible values for status are: Installed and Not
Installed (Factory Default).
48

Duplex Control Module (DCM) Option

Possible values for status are: Installed and Not
Installed (Factory Default).

IGV Output Type

[type]
Inlet Guide Vane Output:
Press (+)(-) to Change Setting
Possible values for Y are: Stepper Motor (Factory
Default) and Pulsed.
If Inlet Guide Vane Output is set to Pulsed and the
Hot Gas Bypass Option is currently set to Installed,
the Hot Gas Bypass Option will be set to Not
Installed and the following will be displayed for 3 sec
to indicate the change.
Hot Gas Bypass Option
Has Been Set to Not Installed

Oil Pressure Protection

Oil Pressure Protection:
[status]
Press (+)(-) to Change Setting
Possible values for [status] are: Transducer (Factory
Default), and Diff Switch, Xducer & Switch.

Programmable Analog Output

Program Analog Output: [Output]
[status]
Press <+> <-> To Change Setting
Possible values of [Output] are:
Not Used
% RLA
DCM Option: [status]
Press (+)(-) to Change Setting
% Cond Pres
Refrig Diff Pres
[Y]
CVHE-CLD-1A