6
Reconstruction time for
the first line in receive
mode
0: 6s 1: 12s
7
Not used
G3 Switch 0B - Not used (do not change the settings).
G3 Switch 0C (SP No. 1-105-013)
No
Function
0-
Not used
3
4-
Select detection of DTMF/DP detection
5
when using remote switch.
00: DTMF+PSTN (Simultaneous
detection)
01: DTMF
10: DP (10 PPPS)
11: DP (20 PPS)
6-
Not used
7
G3 Switch 0D - Not used (do not change the settings).
G3 Switch 0E (SP No. 1-105-015)
No
Function
0-
Set CNG send time interval
7
Some machines on the receiving side may not be able to automatically switch the 3-second
CNG interval.
High order bit
Low order bit
D0CK
When the sending terminal is controlled by a computer, there may
be a delay in receiving page data after the local machine accepts
set-up data and sends CFR. This is outside the T.30
recommendation. But, if this delay occurs, set this bit to 1 to give
the sending machine more time to send data.
Refer to error code 0-20.
ITU-T T.30 recommendation: The first line should come within 5 s of
CFR.
Do not change the settings.
Comments
Do not change these settings.
This setting determines how to detect the signals
from the handset when remote switch is active.
Do not change these settings.
Comments
3000-2250ms: 3000-50xNms
3000 – 50 x Nms 0F (3000 ms) <= N <= FF (2250 ms)
00-0E(3000-3700ms: 3000+50xNms
3000 – 50 x Nms 0F (3000 ms) <= N <= 0F (3700 ms)
90
Bit Switches – 4
SM