Error Codes
Code
0-06
The other terminal did not reply to
DCS
0-07
No post-message response from the
other end after a page was sent
0-08
The other end sent RTN or PIN after
receiving a page, because there were
too many errors
0-14
Non-standard post message response
code received
SM
Meaning
Suggested Cause/Action
Cross reference
•
See error code 0-04.
•
Check the line connection.
•
Try adjusting the TX level and/or cable
equalizer settings.
•
Replace the FCU (PCB2).
•
The other end may be defective or
incompatible; try sending to another machine.
•
Check for line problems.
Cross reference
•
See error code 0-04.
•
Check the line connection.
•
Replace the FCU (PCB2).
•
The other end may have jammed or run out of
paper.
•
The other end user may have disconnected the
call.
•
Check for a bad line.
•
The other end may be defective; try sending to
another machine.
•
Check the line connection.
•
Replace the FCU (PCB2).
•
The other end may have jammed, or run out of
paper or memory space.
•
Try adjusting the TX level and/or cable
equalizer settings.
•
The other end may have a defective
modem/FCU (PCB2); try sending to another
machine.
•
Check for line problems and noise.
Cross reference
•
TX level - NCU Parameter 01 (PSTN)
•
Cable equalizer - G3 Switch 07 (PSTN)
•
Dedicated TX parameters in Service Program
Mode
•
Incompatible or defective remote terminal; try
sending to another machine.
21
D0CK