Code
because of an abnormal handshake in
the V.34 control channel
6-99
V.21 signal not stopped within 6 s
9-30
HDD write error
9-31
HDD control error
9-32
HDD read error
9-33
HDD fatal error
13-
SIP user name registration error
17
13-
SIP server access error
18
13-
SIP authentication error
24
13-
Network I/F setting error
25
13-
Network I/F setting error at power on
26
13-
IP address setting error
27
14-
SMTP Send Error
00
14-
SMTP Connection Failed
01
14-
No Service by SMTP Service (421)
02
D0CK
Meaning
Suggested Cause/Action
•
If the same error occurs frequently, replace the
FCU (PCB2).
•
Defective remote terminal.
•
Replace the FCU (PCB2).
•
Check the connection of the HDD.
•
If the problem persists, replace the HDD and/or
harness.
•
Double registration of the SIP user name.
•
Capacity for user-name registration in the SIP
server is not sufficient.
•
Incorrect initial setting for the SIP server.
•
Defective SIP server.
•
Registered password in the device does not
match the password in the SIP server.
•
IPV4 is not active in the active protocol setting.
•
IP address of the device is not registered.
•
Active protocol setting does not match the I/F
setting for SIP server.
•
IP address of the device is not registered.
•
IP address of the device is not registered.
•
Error occurred during sending to the SMTP
server. Occurs for any error other than 14-01 to
16. For example, the mail address of the
system administrator is not registered.
•
Failed to connect to the SMTP server (timeout)
because the server could not be found.
•
The PC is not ready to transfer files.
•
SMTP server not functioning correctly.
•
The DNS IP address is not registered.
•
Network not operating correctly.
•
Destination folder selection not correct.
•
SMTP server operating incorrectly, or the
destination for direct SMTP sending is not
correct.
•
Contact the system administrator and check
28
Error Codes
SM