Ricoh IM C300 Service Manual page 1533

Table of Contents

1: Direct sending on

Action when the external

handset goes off-hook

0: Manual tx and rx

1: Memory tx and rx

operation (the display

remains the same)

System Switch 0F (SP No. 1-101-016)

Country/area code for

functional settings (Hex)

Setting this switch to "0" masks the direct sending function on the

operation panel so direct sending with ScanRouter cannot be

0: Manual tx is possible while the external handset is off-hook.

However, manual tx during handset off-hook may not be sent to a

correct direction. Manual tx is not possible.

1: The display stays in standby mode even when the external

handset is used, so that other people can use the machine for

memory tx operation. Note that manual tx and rx are not possible

with this setting.

Do not change these settings.

This country/area code determines the factory settings of bit

switches and RAM addresses. However, it has no effect on the

NCU parameter settings and communication parameter RAM

Cross reference

NCU country code:

SP No. 2-103-001 for G3-1

SP No. 2-104-001 for G3-2

SP No. 2-105-001 for G3-3

16: Australia

18: Singapore

19: Malaysia

Bit Switches – 1

Chapters

Table of Contents