Ricoh IM C300 Service Manual page 1511

Code
15- Memory Access Error
93
15- Incorrect ID Code
94
15- Transfer Station Function
95
16- No IP address registered
00
22- Original length exceeded the
00 maximum scan length
22- Memory overflow while receiving
01
22- TX or RX job stalled due to line
02 disconnection at the other end
22- The machine cannot store received
04 data in the SAF
22- No G3 parameter confirmation answer
05
22- The fax number / e-mail address
06 entered or selected by the user does
not match that of the destination. (This
may occur because of a bug.)
D0CK
Meaning Suggested Cause/Action
•
Transaction could not complete due to a
malfunction of SAF memory.
•
The machine rejected an incoming e-mail for
transfer request, because the ID code in the
incoming e-mail did not match the ID code
registered in the machine.
•
The machine rejected an incoming e-mail for
transfer because the transfer function was
unavailable.
•
The machine does not get an IP address
because the DNS server has not been
registered for the remote machine or IP address
of the remote machine has not been registered.
•
Register the DNS server for the remote
machine or configure an IP address of the
remote machine.
•
Divide the original into more than one page.
•
Check the resolution used for scanning. Lower
the scan resolution if possible.
•
Add optional page memory.
•
Wait for the files in the queue to be sent.
•
Delete unnecessary files from memory.
•
Transfer the substitute reception files to an
another fax machine, if the machine's printer is
busy or out of order.
•
Add an optional SAF memory card or hard disk.
•
The job started normally but did not finish
normally; data may or may not have been
received fully.
•
Restart the machine.
•
Update the ROM
•
Replace the FCU (PCB2).
•
Defective FCU (PCB2) board or firmware.
•
Software error.
Install lateset FCU (PCB2) firmware.
•
FCU (PCB2) board defective
Replace the FCU (PCB2).
36
Error Codes
SM