Bit Switches – 1
1: Enabled (default)
6
Conditions for printing the protocol
dump list
0: Print for all communications
1: Print only when there is a
communication error
7
Not used
System Switch 0A (SP No. 1-101-011)
No Function
0-
Not used
3
4
Dialing on the ten-key
pad when the external
telephone is off-hook
0: Disabled 1: Enabled
5
On hook dial
0: Disabled 1: Enabled
6-
Not used
7
System Switch 0B - Not used (Do not change the factory settings.)
System Switch 0C - Not used (Do not change the factory settings.)
System Switch 0D - Not used (Do not change the factory settings.)
System Switch 0E (SP No. 1-101-015)
No Function
0-
Not used
1
2
Enable/disable for direct
sending selection
0: Direct sending off
SM
from the memory when the power was turned off last.
NOTE: If "0" is selected, no reports are printed and no
one may recognize that fax data is gone due to a power
failure.
This switch becomes effective only when system switch
00 bit 6 is set to 1.
1: Set this bit to 1 when you wish to print a protocol dump
list only for communications with errors.
NOTE: The memory size is limited. Use this bit switch
only when some log reports are necessary.
Do not change this setting.
Comments
Do not change these settings.
0: Prevents dialing from the ten-key pad while the external
telephone is off-hook. Use this setting when the external telephone
is not by the machine, or if a wireless telephone is connected as an
external telephone.
1: The user can dial on the machine's ten-key pad when the
handset is off-hook.
0: On hook dial is disabled.
Do not change these settings
Comments
Do not change the settings.
Direct sending cannot operate when the capture function is on
during sending. Setting this switch to "1" enables direct sending
without capture.
57
D0CK