Kodak 5500 User Manual page 24

Feeding documents
manually
A-61070 September 1999
7. As you scan documents, set the image level, as required, and
periodically remove documents from the exit hopper.
NOTE: When the image buffer is full, the feeder will turn off and the
image buffer status light will turn red. There may be a
momentary pause in scanning while images are being
transferred to the host computer. Scanning will resume and
the status indicator will change to green when the image
buffer is clear.
8. Press Stop to disable the transport system after the last document
has been scanned, or press End to alert the host computer the
batch or job has ended and to disable the transport system after the
last document has been scanned.
To manually feed documents, follow the steps below:
1. Select the correct scanning operating values.
2. Place the feed shelf in the up or down position (semi-automatic
feeder only), whichever is most convenient.
3. Insert the documents one at a time.
NOTE: Be sure the documents are center-fed so each document
covers the 2 ½-inch required width as indicated by the label
on the feed tray.
3-5