Kodak 5500 User Manual page 59

Kodak scanner user's guide 5500, 7500
Hide thumbs Also See for 5500:
Table of Contents

Advertisement

Code
Message Displayed
E118
Check correct IA/level
E119
E127
Wait image buffr full
E128
Doc interval too narrow
E132
Printer - not machine enabled
E133
Bar Code - not machine
enabled
E134
Patch - not machine enabled
E135
Printer hardware error
E136
Bar Code hardware error
E137
Footswitch - not machine set
E138
Accessory off via Fnc code
6-4
Description/Action Required
Document image level assignment and next image
address input conflict.
Specify another document image level, or use the
Next key to enter a valid image address.
The image buffer is too full. The feeder will stop
feeding documents, but the documents in the
transport system will continue to be scanned.
Scanning will automatically continue when the image
buffer is clear. No action is required. Wait for the
message to clear as the host retrieves images from
the scanner.
The document interval has become too narrow.
Check and adjust the feed and separator roller gap.
Tried to use the Document Printer, but the accessory
is not enabled. Enter function code F40 to enable the
Document Printer.
Tried to use the Bar Code Reader, but the accessory
is not enabled. Enter function code F60 to enable
bar code reading.
Tried to use the Patch Reader, but the accessory is
not enabled. Enter function code F50 to enable the
Patch Reader.
Tried to use the Document Printer after an E207
Printer Hardware error was displayed at power-on
and the C key was used to clear the message. Press
C to clear the error condition.
Tried to use the Bar Code Reader after an E208 Bar
Code hardware error (or E640-645 Bar Code Health
Check error) was displayed at power-on and the C
key was used to clear the message. Press C to clear
the error condition.
Tried to use the Footswitch, but the accessory is not
enabled. Call Service to change the mode
configuration.
Tried to use an accessory that is enabled for the
current application mode but is currently disabled via
a function code. Press C to clear the error, then
press F and enter the function code that enables the
desired accessory.
A-61070 September 1999

Advertisement

Table of Contents
loading

This manual is also suitable for:

Digital science 5500Digital science 7500

Table of Contents