Kodak 500 User Manual page 38

Error Code
E118 Check
Correct IA/Level
E119 Check
Correct IA/Level
E127 Wait
Image Buffr Full
E128 Doc Interval
Too Narrow
E132 Printer
Not Machine Enabled
E133 Bar Code
Not Machine Enabled
E134 Patch
Not Machine Enabled
E135 Printer
Hardware Error
4-4
Description
The operator pressed the Next
key, input a new image address
and fed a patch document that
conflicts with the image level of
the Next key input. The image
address defined by the Next key
will be assigned to the next
document and the patch level will
be ignored.
A T-Patch document has been fed
and then the Next key was
pressed to input a new image
address. The image address of
the T-Patch is ignored and the
Next key input is assigned to the
next document.
The image buffer has become too
full. The feeder stops feeding
documents but the documents in
the transport system continue to
be scanned. When the image
buffer empties, the message will
clear and scanning automatically
continues.
The document interval has
become too narrow. If not
corrected may lead to false
document jams or incorrect
scanning and image addressing.
Tried to use a Document Printer
function code (F40-49) but the
Document Printer accessory is
not enabled.
Tried to use a Bar Code Reader
function code (F60-65) but the
Bar Code Reader accessory is
not enabled.
Tried to use a Patch Reader
function code (F50-55) but the
Patch Reader accessory is not
enabled.
Tried to use a Document Printer
function code (40-49) after the
following two events occurred:
• The message E207 Printer
Hardware Error was displayed
at power on and
• The C key was used to clear
the message (but the error
status was not cleared.
Action
After pressing C, verify the current
image level and image address.
After pressing C, verify the current
image level and image address.
Wait for the error message to clear
and the feeder to automatically
continue scanning. If the feeder does
not automatically start, it is possible
the host is not reading the images
from the image buffer. If this happens,
contact your system administrator.
Adjust the gap adjustment knob to
widen the document interval. See
Adjusting the Feed Roller and
Separator Roller section in this
manual. Press C to clear the
message.
Press C to clear the error condition. If
the printer accessory is desired,
service must be called to change the
mode configuration.
Press C to clear the error condition. If
the bar code reader accessory is
desired, service must be called to
change the mode configuration.
Press C to clear the error condition. If
the patch code accessory is desired,
service must be called to change the
mode configuration.
Press C to clear the error condition.
A-61408 September 1995