Kodak 500 User Manual page 81

A-61408 September 1995
10. Replace the Imaging Guide with the bar code adhered to it.
NOTE: Refer to the illustrations below and to Section 5,
Scanner Maintenance (Cleaning Imaging Guides) for
details on how to remove the Imaging Guides.
Rear Imaging Guide
Saddle Mount
Rear Imaging Guide
Mounting Pin
Front Imaging
Guide Saddle Mount
Transport Plate
11. Swing the Vertical Transport Plate closed and rotate the
release handle 180 counterclockwise (so that the red arrow
aligns with the red rectangle) to latch the plate.
Red Arrow
Red Rectangle
12. Close the Side Access Door.
13. Release and lower the Horizontal Transport Plate back into its
original position.
14. Lower the release bar and latch the Front Scan Module into
its original position.
15. Close the Lower Access Door.
16. Close the Upper Access Door.
C-9