Front And Rear Document Printers - Kodak 500 User Manual

Kodak user's manual imagelink tm scanner 500
Hide thumbs Also See for 500:
Table of Contents

Advertisement

Function Codes
Performing the Print Test Function
A-61408
September 1995
The following function codes are available if the Document Printer
500 Accessory has been installed and the current application
mode allows use of the Document Printer 500 Accessory.
F40
Front and Rear Document Printers On/Off
F41
Front Document Printer On/Off
F42
Rear Document Printer On/Off
F44
Omit Printing on Next Document On/Off
Inhibits printing on the next document entering the
Feeder.
This applies to both the Front and Rear Document Print-
ers.
F45
Print Test
Refer to, Performing the Print Test Function.
F46
Front Document Printer Vertical Start Print Position
Allows the operator to change the vertical start print
position of the Front Document Printer.
F47
Rear Document Printer Vertical Start Print Position
Allows the operator to change the vertical start print
position of the Rear Document Printer.
Follow these steps to use the On/Off functions:
1. Press the F Key.
2. Press the numeric key(s) that correspond to the desired
function code.
3. Press Enter.
NOTE: If the associated accessory is not installed, an error
message will be displayed.
4. Press the numeric key 1 to turn the function ON; or press the
numeric key 0 to turn the function OFF.
5. Press Enter. (Press C to cancel the function.)
Function Code F45 can be used to verify the operation, vertical
start print position, and print quality of the Front and Rear Docu-
ment Printers. No other accessories (Bar Code Reader 500, Patch
Reader 500, etc.) can be enabled during the test. In addition,
scanning, Image Address increments, document counting, etc. will
not occur during this test.
To perform the print test function:
1. Press the F Key.
2. Press the numeric keys 4 and then 5.
3. Press Enter. A message will be displayed in the Status
Display indicating that the print test function is being per-
formed: Either Print Test or Feed Document(s).
4. Feed as many documents as needed to verify the operation,
position, and print quality of the information printed.
5. Press Stop.
D-7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Imagelink 500Imagelink 500dImagelink 500s

Table of Contents