Function Code Listing; Select Application Mode; Restore Application Mode; Level 0 - Kodak 500 User Manual

Function Code Listing

3-4
F01

Select Application Mode

Allows you to select one of the scanner's predefined application
modes. Enter a value from 1–18.
F02

Restore Application Mode

Allows you to restore the current application mode to its original
user-defined preprogrammed status.
F04 Count Only On/Off
Allows you to count the number of documents entering the scan-
ner without scanning the documents. The Count Only counter will
be reset to 0 when this function is selected and displayed in the
Status Display. All accessories are inhibited when the Count Only
function is selected.
F05

Accessory Status

Displays the current statuses of the system's optional accessories
(except Footswitch), software functions (Skew Monitor function
and Length Monitor function), and confirmation tone selections.
The status of the first accessory/function is indicated in the Status
Display; press Enter to display, one at a time, the status of the
next and subsequent accessories and functions.
"On Via Fnc Code" and "Off Via Fnc Code' indicate the optional
accessory, software function, or confirmation tone has been
enabled or disabled with the appropriate function code. "Not
Machine Set" indicates the optional accessory has not been
software enabled for the scanner.
F07

Level 0

Allows you to define the next document scanned a Level 0 docu-
ment.
F08

Last Image Address

Allows you to display the image address of the last document
scanned.
F09

Total Document Counter

Allows you to display the total number of documents that have
entered the feeder as Level 3, Level 2, Level 1 and Level 0
documents. By entering 0, or any valid number, the Total Docu-
ment Counter can be reset or preset. The Document Counter also
resets to 0 when 999,999,999 is reached. Reset and preset will
not affect the individual level counters.
A-61408 September 1995