Updating The Display's Firmware - Smart Technologies Smart Board MX Series Installation And Maintenance Manual

Chapter 4 Maintaining the display
You can connect the display to a network using Wi-Fi or an Ethernet connection. Before connecting the
display, your organization's network administrators need to configure the network to allow users to
update the display's firmware automatically.
To configure the network
1. Open the port required for automatic firmware updates:
Protocol
TCP
2. Add the following URLs to the network allowlist:
o http://api.lango-tech.cn
o http://lango-tech.cn/
o http://otaa.lango-tech.cn
http://otag.lango-tech.cn
o
o http://downloads.smarttech.com

Updating the display's firmware

For SMART Board MX series displays
The display checks for firmware updates automatically, provided the display's date and time are set
correctly (see Date & Time on page 86) and the display is connected to the internet. The display notifies
you when a firmware update is available.
When a display is connected to the Internet and an update for the display's firmware is available, the
display shows a message that an update is available.
Tap Update to update the display's firmware.
l
Tap Ignore to skip that specific firmware update. The display won't apply that update even if you
l
check for updates manually.
Tap Cancel to update the display's firmware at a later time.
l
The display applies the firmware update automatically if no options are selected after a short time.
When the update is installing, touch, the front control panel and remote control will not respond.
smarttech.com/kb/171555
Port range
80
64