Table of Contents
Advertisement
Installing the Interactive Pen Display
CAUTION
Turn off your interactive pen display and shut down your computer before you
connect any cables. Otherwise you may damage the interactive pen display or your
computer.
Attaching the Interactive Pen Display to the Mounting Arm
Before you connect the cables, attach the interactive pen display to the top of the mounting arm.
Mounting
Arm
To attach the interactive pen display to the mounting arm
CAUTION
The interactive pen display is heavy. Get an assistant to support the interactive pen
display when you are inserting the screws that attach the interactive pen display to
the mounting arm.
CAUTION
Grip the interactive pen display on the sides or the back when you hold or move it.
Don't apply pressure to the screen.
TIP
Turn the top plate of the mounting bracket until it is horizontal. This makes it easier
for your assistant to support the interactive pen display when you're aligning it in
the next step.
1. Align the four holes on the back of the interactive pen display with the holes in the top plate of
the mounting arm.
2. Insert the four TORX® screws from the accessory kit through the holes in the top plate and
into the interactive pen display. When you have inserted all four of the screws, tighten them
using the TORX security key from the accessory kit.
NOTE: If you lose one of the supplied TORX screws, replace it with a mounting screw of the
same length. Don't use a longer mounting screw as this could damage the interactive pen
display.
Addendum to the SMART Sympodium MP250 Interactive Lectern Installation and User's Guide
Top Plate
NOTE: For clarity, the
mounting arm is shown
without the counter top.
3
Advertisement
Table of Contents
