Chapter 4 Maintaining The Display; Turning Off, Turning On, And Resetting Smart Board Mx (V3, V2 And V2-C) Series Displays - Smart Technologies Smart Board MX Series Installation And Maintenance Manual

Chapter 4 Maintaining the display

In most situations, you can put the display into Sleep or Standby when not using it following the
instructions in the SMART Board MX and MX Pro series interactive displays user guide
(smarttech.com/kb/171554).
In some situations, such as when you transport the display or clean its screen, you need to turn the
display off. You can turn it back on after.
You can also reset the display.
Turning off, turning on, and resetting SMART Board MX (V3, V2 and V2-C)
series displays
To turn the display off
1. Press the Power button
A slider appears on the screen.
2. Move the slider to the right.
3. Flick the switch beside the AC power inlet to the OFF (O) position.
Note
Wait at least 30 seconds before turning the display back on.
To turn the display back on
Note
Touch is not available right after waking up the display or turning it on. Wait a few seconds and then
the display will respond to touch.
1. Flick the switch beside the AC power inlet to the ON (I) position.
2. Press the Power button
To reset the display
Press and hold the Power button
The display resets.
smarttech.com/kb/171555
on the front control panel or the remote control for five seconds.
on the front control panel or the remote control.
on the front control panel or the remote control for 10 seconds.
55