Power State Commands - Smart Technologies Smart Board MX Series Installation And Maintenance Manual

Appendix C Managing SMART Board MX (V3, V2, and V2-C) series displays using RS-232
To increase or decrease the value of a setting
Use the set command to increase or decrease the value by a designated number.
This example increases the volume by 5:
>set volume+5
volume=70
>
This example decreases the volume by 15:
>set volume-15
volume=55
>

Power state commands

Get command
get powerstate
The display has six power states:
Power state Description
ON The display is in normal operating mode.
smarttech.com/kb/171555
Set command
set powerstate[Value]
Where [Value] is one of the following:
=on
l
=ready
l
=standby
l
=powersave
l
Note
If the display is in UPDATEON or
UPDATEREADY state, it might not
change power states after receiving
the command.
Response
powerstate=[Value]
Where [Value] is one of the following:
on
l
ready
l
standby
l
powersave
l
updateon
l
updateready
l
105