Updating System Software; Applying An Automatic System Software Update Manually; Updating System Software Manually - Smart Technologies SMART Board 6000S Series Installation And Maintenance Manual

Hide thumbs Also See for SMART Board 6000S Series:

Table of Contents

Chapter 4 Maintaining the display

To transport the display

See Moving the display to the installation site on page 20.

Updating system software

When an update to the system software or firmware is available, the display downloads the update in

the background then waits for four hours of inactivity. When that happens, the display shows a

two-minute countdown before the update begins. You can interrupt the countdown at any time. The

display shows a blank screen for several minutes. When the update is complete, the iQ home screen, or

input lobby appears.

Note

You can configure your organization's network to allow or prevent automatic system software and

firmware updates (see Connecting to a network).

If the display has downloaded the system software update but hasn't yet applied the update, you can

start the update process manually from Settings.

To apply an automatic system software update manually

1. From the Home screen, tap Settings

2. Scroll to Software Update.

3. Under Check for Updates Now , tap Apply Update Now.

The display turns off and then turns back on. The display then applies the update.

You can download system software updates at smarttech.com/downloads and update your display

using a USB drive.

Note

Instructions for downloading and installing system software updates are provided on the software

downloads page.

smarttech.com/kb/171414

Table of Contents

Table of Contents