Making Power And Computer Connections - Smart Technologies SMART Board SBID Interactive Display 6052i Installation And User Manual

To make power and
computer connections
12 | CH A P T E R 3 – S ETTI NG UP THE INTE RACTIVE DI SPL AY

Making Power and Computer Connections

Touch Connection
Panel USB 2.0 Cable
Touch Connection
Panel Power Cord
1. Connect the supplied VGA cable from your computer or SMART hub's video
output connection to the terminal pane. For more information, see Connecting
External Equipment with the Terminal Panels on page 18.
2. Connect the supplied power cable from the AC IN connector in the interactive
display's bottom terminal panel to the AC power outlet.
NOTE
Optionally, you can cover the bottom terminal panel with the supplied cover to
secure the cables. Six screws are supplied for this cover.
3. Connect the supplied power cable from the touch connection panel of the
interactive display to the AC power outlet.
4. Connect the supplied USB 2.0 cable from the touch connection panel to a USB
2.0 receptacle on the computer.
NOTE
USB 1.1 cables or receptacles result in reduced performance.
5. Connect your computer to the Internet.
IMPORTANT
If your interactive display was purchased with SMART Meeting Pro Premium,
you require an Internet connection for software installation.
6. Connect the power cable from your computer to the wall outlet.
Display
Power Cord
Display VGA
Cable
Computer
Power Cord
Internet
Connection