Commands - Smart Technologies SMART Board MX100 Series Installation And Maintenance Manual

APPENDIX B
REMOTELY MANAGING THE DISPLAY
With the exception of get powerstate and set powerstate, commands are available only when
the display is in ON power state.

Commands

Get command
get powerstate
get input
72 smarttech.com/kb/171288
Set command
set powerstate[Value]
Where [Value] is one of the following:
= on
l
= ready
l
NOTES
If the command returns an
l
"invalid command" message,
add spaces around the
operator symbol (=).
The screen is in a low power
l
state and doesn't respond to
any RS-232 commands.
Disable Power saving mode to
prevent the display from
entering SOFT OFF. See
Power saving mode on
page 64.
If the display is in UPDATEON
l
or UPDATEREADY state, it
might not change power states
after it receives the command.
set input[Value]
Where [Value] is one of the following:
=OPS
l
=HDMI1
l
=HDMI2
l
=HDMI3
l
=VGA
l
Response
powerstate=[Value]
Where [Value] is one of the following:
on
l
ready
l
updateon
l
updateready
l
input=[Value]
Where [Value] is one of the following:
=OPS
l
=HDMI1
l
=HDMI2
l
=HDMI3
l
=VGA
l
=ANDROID
l
NOTE
=ANDROID is the display's settings.