Table of Contents
Advertisement
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Shut off the engine.
4.
Remove the spark-plug wire from the spark plug;
refer to your Operator's Manual.
2
Preparing the Cutting Unit
No Parts Required
Procedure
1.
On the cutting unit, loosen the mounting screws
that secure each end of the front roller to the
height-of-cut arms
1. Plow bolt
2. Roller
3. Height-of-cut arm
4. Adjusting screw
(Figure
2).
Figure 2
5. Washer
6. Flange nut
7. Roller-mounting screw
8. Cutting-unit assembly
2.
Remove the plow bolts, washers, and locknuts
securing the height-of-cut arms to each end of
cutting unit
arms and roller.
Note:
Save the removed hardware to install the
new height-of-cut arms.
3.
Remove the height-of-cut adjusting screws and
roller-mounting screws from the height-of-cut
arms
(Figure
Note:
Save the roller mounting screws and the
roller for later installation.
4.
Remove the 2 bolts (5/16 x 2-1/4 inches) from
the 2 nuts (held captive by the side plate)
securing the counterweight on the side plate
of the cutting unit. Remove the counterweight
(Figure
3).
Note:
You may discard the cutting unit
counterweight and the mounting bolts.
1. Weight
g275540
2. Bolt
5.
Restrain the reel to remove the bearing nut; refer
to
Restraining the Reel for Removing Threaded
Inserts (page
3
(Figure
2). Remove the height-of-cut
3).
Figure 3
3. Bearing nut
4. Cap
15).
g281094
Advertisement
Table of Contents
