Table of Contents
Advertisement
Transporting the Machine
When you wish to mow without the groomer or need
to transport the machine, move the quick-up lever to
the T
position
RANSPORT
Note:
This moves the groomer reel into a raised
position.
Figure 21
1. T
position
RANSPORT
Maintenance
Changing the Gearbox
Lubricant
Service Interval:
•
After the first 100 hours
•
Every 500 hours/yearly (whichever comes first)
1.
Clean the external surfaces of the groomer
housing.
Important:
Ensure that there is no dirt or
clippings on the outside of the groomer
housing; if debris gets inside of the groomer
it can damage the gearbox.
2.
Remove the drain plug on the bottom of the
housing
(Figure
22).
(Figure
21).
2. O
position
PERATION
1. Air-vent plug
2. Fill plug
3.
Remove the fill plug on the side of the housing
and loosen the air vent plug on the top so air
can pass through
4.
Align a suitable container beneath the oil drain
g287375
port to catch drained oil.
5.
Tip the cutting unit (as shown in
until the drain port is at the bottom to ensure
complete drainage.
6.
Slowly rock the cutting unit back and forth to
ensure that the oil has completely drained from
the housing. When the oil is completely drained,
place the cutting unit on a level surface as
shown in
13
Figure 22
3. Drain plug
(Figure
22).
Figure
24.
g286955
Figure
23)
Advertisement
Table of Contents
