Table of Contents
Advertisement
5.
Insert and center the roller shaft between the
height-of-cut (HOC) brackets and secure it with
2 mounting screws
You can install the mounting screws in the front
(as shown in
Figure
of the HOC brackets. Installing the screws in
the front side will allow the groomer to clear the
roller; installing them in the rear side will allow
the groomer to interlace with the roller.
Figure 14
Mounting screws installed to front side of HOC brackets
1. Roller
2. Mounting screw
Figure 15
Mounting screws installed to rear side of HOC brackets
1. Groomer guard
2. Mounting screw
6.
Attach the groomer guards to both sides of the
roller shaft
(Figure
(Figure 14
or
Figure
15).
14) or rear side
(Figure
3. Height-of-cut bracket
(HOC) assembly
4. Groomer guard
3. Height-of-cut bracket
(HOC) assembly
4. Roller
14).
7.
Torque the groomer guards to 22 to 24 N∙m (16
to 18 ft-lb).
Note:
For setups where additional spring force
is required, install the optional flange nut (Part
15)
No. 3290-357) to the eye bolt to compress
the height-of-groom springs at a low height of
groom.
When using this optional part, set the spring
length to 19 mm (3/4 inch) when the groomer is
in the engaged position
g287988
1. Set the spring length to
19 mm (3/4 inch) in the
engaged position.
g287989
8
(Figure
16).
Figure 16
2. Optional flange nut (Part
No. 3290-357)
g283296
Advertisement
Table of Contents
